![]() ![]() Select which encryption type is applicable for your SMTP Server from the dropdown menu. If you are sending attachments, such as snapshots, make sure to leave the checkbox for Attachment as enabled. In the Subject line, you can leave the subject as default (NVR ALERT) or you can change the subject line to whatever you would like it to say. This will be the email address the alerts are being sent from. Enter the sender's email address into the Sender field. Next, enter the receiver's email address into the Receiver field, this will be the email address that the alerts will be emailed. As a general rule of thumb, a lways verify if your Email Address and password were entered correctly before proceeding. Enter the password for that email address into the Password field. ![]() Once this information has been filled out, enter the email address being used into the Username field. Popular Email Servers, Ports, and Encryption SMTP Server For more information on which email SMTP servers, port numbers, and encryption types to use, refer to the provided table below. Then, enter the port number for your SMTP server in the Port field. Type in the SMTP server for your email service provider in the SMTP Server field. In the network menu, click on the Email tab and enter the requested information into the interface. If you have direct access to your NVR and would like to set up email alerts, log into your device, and in the Management section click on Network. To set up email alerts using your NVR, please refer to the information provided below. What am I missing, how can this be fixed?Įdit1: Can ping the camera after added the static route on the router, but no luck with sending email.Setting up email alerts for your NVR will allow you to receive motion detection alerts straight to your email address. I can ping 192.168.254.1 which is the internal nic of the router. IPV4 Default Gateway: 192.168.1.1 (My Unifi Router/UDM)Ĥ. SMTP server: (have enabled less secure apps on settings) My Hikvision cam and set the following email config: My Hikvision cam and set the following network config:ĭefault Gateway: 192.168.1.10 (also tried setting it to the unifi router gateway 192.168.1.1)ģ. Hikvision cameras connected to nvr to send direct emailĢ. Shared some config details and tests I ran below. However, that did not work with my Unifi Dream Machine route. ![]() ![]() I followed a few threads and figured out I need to add a static route on my router/modem to get Front Hikvision cam (DS-2CD2386G2-ISU/SL) to be able to send out emails/notifications. When I test the smtp configuration () to send out a test email, this returns an error. However, it was a disappointment that the camera cannot direct talk to the WAN outside of the NVR network and send emails/notifications. So my security installer/seller recommended, to upgrade front camera facing the road to try and get human/vehicle detection working. The Hilooks NVR/Cameras do not support human/vehicle detection which is really important to receive these alerts. My setup, I have Hilook NVR (NVR-108MH-C/8P) and hilook cameras (DS-7608NI-I2/8P) + 1 Front Hikvision cam (DS-2CD2386G2-ISU/SL) setup. ![]()
0 Comments
Leave a Reply. |